Tail Pad - Basic

Surfboard Deck Grip NZ / Traction Pad NZ - Basic 3 Piece

• 3 piece
• black
• premium 3M adhesive
• diamond square cut for maximum grip 
• 25mm sloped tail kick
• 3mm arch bar
• unbranded premium quality plain 3 piece grip
• super good value $34.95

This is a basic, solid, no-frills deck grip with premium 3M adhesive and diamond square cut traction for super good grip. Very understated in black - for those who let their surfing do the talking 😉 If you think surfboards should be white and grips should be black, then this great value traction pad is your perfect match.

Limited stock, get in quick.

Protect your board and increase traction by applying deck grip as follows

• Make sure your board is 100% clean and dry from any wax, debris or moisture. Hint: use a Curve Wax Scraper to make it easier to remove the bulk of your wax. Remove all remaining wax residue with an old rag, or rub in some fiberglass dust (ask your local shaper) or even better Sticky Johnson Wax Remover
• Position rear edge of surfboard grip over back base of your rear fin – getting close to but not overlapping leash plug. For wider boards you may want to spread the grip side bars out (taking care not to overlap rails) and for narrower boards leave as a solid pad.
• Pencil an outline of desired traction pad position.
• Line up centre surfboard grip with centre surfboard stringer and apply slowly from bottom up, avoiding air bubbles.
• Line up surf grip side bars equally and apply. Leave the traction pad for at least 12 hours to fully dry.
• Your new grip is ready to rip!